Knowledge of Engineering and Site commissioning of Control & Instrumentation Packages like Turbine Control System (TCS) and Turbine Protection System (TPS), Turbine Supervisory Instrument (TSI) System, Data Acquisition System, Pneumatic control valves, Field instruments, LIE/LIR, Instrument hook ups, Cables, PG Test Monitoring System etc.
Preparation and review of P&ID; diagram.
Preparation of data sheet for Field instruments, Special instruments, JB, Cable trays, Instrument fitting etc.
Preparation of instrument index, I/O list, Cable schedule, Junction box schedule, Wiring diagram, Termination Diagram, Instrument hookup drawing, Instrument location drawing, Earthing layout, Control schematic diagram and loop diagram, Instrument installation diagram.
Preparation of design basis and control philosophy for various instrumentation process system and packages/skids.
Review and preparation of material requisition/RFQ, vendor offer evaluation, technical bid analysis.




Review of vendor document such as instrument datasheet, Panel wiring, Panel GA drawing, Power calculation, Earthing drawing.
Preparation and review of PLC Architecture, I/O mapping, review of PLC panel wiring and GA drawing and HMI and SCADA graphics.
Coordination with inner discipline such as Electrical, Mechanical, Process and Civil for instrumentation interfaces.
Coordination with external stake holders such as vendor, clients and consultants.
Control and Protection logic for steam turbine.
Conducting Factory acceptance test.
Conducting Site acceptance test.
Site support during instrument installation, DDCMIS (TCS, TPS) commissioning, TSI system commissioning, unit startup, Overhauling.
Willing to travel as required for job responsibilities (travelling around 40% approx.).

📌 Control and Instrumentation(C&I) Engineer for Project Engineering (Badayla Chorasi)
🏢 Larsen and Toubro
📍 Badayla Chorasi