To assist the PM & other project team members to execute Detailed Engineering and FEED job in a project. Support department to establish the and Update procedures and standards

Performing Simulation studies and developing Heat & Mass Balance sheet

Flare, Blowdown & Depressurization calculations

Sizing of Equipment, Instrument and Lines

Performing Hydraulic calculation of network lines

Estimation of Power load

Preparation of Engineering documents, reports & Operating manual

Preparation of PFD, P&ID;

Preparation of PROTECTED Charts, Cause & Effect Diagram

Preparation of Datasheets for Rotating, Static and Instruments

Guiding Project management team on emergency

Forecasting deliverables affect the schedule

- To review contract scope, prepare list of deliverables and provide inputs to planning based on budgeted manhours.
- To check and approve all documents/ deliverables using checklists and checkprints.
- To be responsible for all the technical decisions
- To ensure that work is executed on schedule and within the agreed manhours
- To initiate and discuss design changes with the FH and Project
- Manager/ Project Engineer and raise DCS (Design Change Sheet)
- To ensure that all documents/deliverables (originals and copies) and correspondence are filed (refer CP-5007).
- To ensure that the Time Sheet Procedures are followed by his teammembers.
- Plan,



allocate/reallocate, monitor work and man-hours for his team members through FH.
- To anticipate and discuss any potential delays and problems, if any,with the FH and /or Project Engineering Manager/Project Engineer.
- To participate in meetings, review the minutes and incorporate the same into further work on the contract.
- To brief the FH on contract status/progress and resolve issue if any
- To ensure that all the documents/deliverables and correspondence, received from other disciplines are reviewed, responded to and/or incorporated appropriately.
- Shall update the Master list (DCI/MCI) containing records of status of all documents generated on a contract
- To co-operate with fellow Lead Engineers and Project Manager/Project Engineer for smooth execution of contracts
- Provide inputs to project manager for project closeout report and lessons learnt
- To ensure Project Quality Plan is implemented for the project.
- To coordinate with Quality for External/Internal audits and take corrective actions for any deviation from procedures.
- To ensure that the CPs/DPs and Project specific procedures are followed
- To follow Quality Objectives and maintain data
- To train the sub-ordinate and enhance the skills of team members.

📌 Lead Process Design Engineer (Mumbai)
🏢 Larsen u0026 Toubro
📍 Mumbai