Job Description Designation: Robotics Engineer (Hardware)
n Full time · 1–3 years experience
n About:
nThis is a full-stack electronics role weighted towards hardware. You will grow into owning the controller board from schematic and layout, through fabrication and bring-up, to the wiring and grounding that ties the robot together — and write the firmware that runs on it.
n
n What you'll do:
n● Design mixed-signal controller PCBs: power tree, component selection, schematic capture and design review (Fusion 360 or KiCad).
n● Lay out multilayer boards: stackup, placement, decoupling, ground and return paths, and routing of noise-sensitive nets.
n● Take boards through fabrication and assembly: fab outputs (Gerbers, drill, pick-and-place), BOM management, and coordinating with PCB vendors.
n● Bring up and validate boards: rail and clock checks, bus signals on the scope, load and thermal checks, and root-causing board-level defects.
n● Write firmware in C on 32-bit ARM Cortex-M microcontrollers: bring-up and test code for new boards, and drivers for sensors and field devices.




n● Plan system-level electrical integration: connectors and wiring harnesses, cabling and termination, fusing, and grounding scheme.
n● Maintain hardware documentation: schematics, BOMs, test points, bring-up reports, wiring diagrams and change history.
nMust have
n● B.E./B.Tech/M.E./M.Tech in Electronics, Electrical, Computer Engineering or equivalent.
n● Hands-on PCB design: schematic capture and multilayer layout in KiCad, Fusion 360, Altium or similar.
n● PCB fundamentals: component selection and footprints, following the layout guidance in a datasheet, decoupling, grounding and return paths, and routing practices.
n● Hardware side of digital interfaces — SPI, I²C, UART, GPIO, CAN/CAN-FD, RS-485, Ethernet — transceivers, termination and biasing.
n● Working embedded C on 32-bit MCUs: able to bring up a board or set up configurations in a vendor ecosystem (STM32CubeIDE, Infineon

📌 Robotics Engineer (Bengaluru)
🏢 NMTronics India
📍 Bengaluru