Key Responsibilities
Operate SAW welding machines for welding plates, beams, structural components, tanks, pressure vessels, and other fabricated assemblies.
Set up the welding machine according to approved WPS (Welding Procedure Specification).
Select and set the correct welding current, voltage, wire feed speed, travel speed, and flux.
Check welding wire, flux, polarity, and machine settings before starting work.
Read and understand fabrication drawings, weld symbols, WPS, and work instructions.
Ensure proper fit-up, alignment, tack welding, and joint preparation before welding.
Monitor welding parameters during operation and make adjustments when required.
Ensure proper flux coverage and maintain consistent welding speed.
Remove slag and clean weld areas after welding.
Visually inspect welds for defects such as cracks, porosity, undercut,



lack of fusion, and incomplete penetration.
Coordinate with fitters, welders, QC inspectors, and fabrication supervisors.
Carry out basic troubleshooting and routine maintenance of SAW equipment.
Maintain welding consumables properly and prevent contamination or wastage of flux and wire.
Follow production schedules and achieve daily production targets.
Maintain proper housekeeping and follow PPE, safety, and 5S requirements.
Report machine problems, welding defects, and unsafe conditions to the supervisor.

Pay: ₹20,000.00 - ₹40,000.00 per month

Advantages:
Provident Fund

Work Location: In person

📌 Saw Operator – Fabrication Wardha (India)
🏢 Mecgale Pneumatics
📍 India