Position Description

- The position of Series Support assembly engineer is key link between Supplier, BTV function & Production. Scope of this position is from Series Production until End of Production models.

- Series Support assembly engineer performs various tasks – Handling of line Complaints & 0 Km failure for Supplier Manufacturing issues, Acknowledgement & Primary analysis , Initiation of containment actions , Finalizing rework / inspection activities in liaison with Supplier & PQE , Effectiveness tracking of containment actions parts, Initiation of quick feedback mechanism for line disruption to avoid line losses ( Downtime).

- Resolution of Quality defects at various checkpoints – CP6, Roll Brake Test, Water test, Drive Test, CP8, Vehicle audit, DKA Audit.

- Problem reporting to Supplier through Global Platform – Konzern Problem Management (KPM)

- Defining & follow-up for Corrective & Preventive actions.

- Focus on internal customer expectations & fulfillment of relevant expectations in time.

- Visit to Supplier to analyze the problems & sustenance of actions.

Primary Responsibilities

- Problem Management

Verification of VW MIS on daily basis.

1.2 In case of Q-relevant issue reported on line , Do the primary analysis for those problems

1.3 Preparation of problem sheet for Q-issues which are booked at checkpoints / audits

1.4 Downtime verification & Internal communication.

1.5 Initiation of containment actions – In case of parts are to be rework then take necessary

Trials to ensure OK parts are available on line





1.6 Assign third party for rework / sorting of affected parts.

- Problem & Containment actions communication

2.1 Communicate problem sheet to Supplier & BTV

2.2 Preparation of Inspection Report & Problem sheet in SPES System

2.3 Problem to be raised in Group System – Konzern Problem Management

2.4 Follow-up with supplier for Corrective & Preventive actions

2.5 Monitor the effectiveness of supplier action / measure..

2.6 Based on the effectiveness closer of KPM & monitoring in the systems.

- Rejection Parts Acknowledgement

3.1 In case of Q-Problem is parts then Acknowledge on NC tag.

Key Responsibilities &Tasks;

3.2 Attend rejection room meeting in respective shift

3.3 Provide Inspection report & Decision on rejection parts – RTV / Claim / Scrap

- Quality Drive

4.1 Actively participation in shop floor meeting – Island, Water test, ECOS, Drive Test, and Front End & Rear End.

4.2 Participation in continual improvement meetings – Cubing , Meisterbock

4.2 Visit to Supplier for resolution of complaints

4.3 Defining & monitoring actions to control & eliminate the defect from Supplier.

Yard Activities

5.1 Prepare documentation & approvals for Yard Activities.

5.2 Co-Ordination with Logistics – FIS & Yard team for dispatch schedule & availability of cars.

5.3 Guideline for Sorting / inspection of parts on Vehicle.

5.4 Final Confirmation from Quality Operation assembly shop once Vehicle is OK.

5.5 Report communication to involved agencies – Logistics , QOA , Assembly & Finish Center

📌 Assembly shop series support engineer (Pune)
🏢 ŠKODA AUTO Volkswagen India Private
📍 Pune