Qualification & Experience
B.E./B.Tech in ECE/RF & Microwave/Electronics with 3 years of relevant experience, or
M.E./M.Tech in RF & Microwave/Electronics/Communication with 2 years of relevant experience.

Key Responsibilities
Design and develop RF/Microwave circuits and subsystems, including RF Amplifiers, Receiver Chains and T/R Modules.
Design and optimize LNA, Driver Amplifier and RF Power Amplifier circuits.
Design and analyze RF receiver chains, including LNA, filters, switches, mixers, attenuators and associated RF interfaces.
Perform device selection, biasing, impedance matching, stability, gain, noise figure, output power, P1dB, linearity and PAE analysis.
Perform RF circuit simulation and optimization using Keysight ADS and AWR Microwave Office.
Support RF PCB design, hardware realization, debugging, and simulation-to-hardware correlation.
Conduct RF measurements using VNA, Spectrum Analyzer, Signal Generator, Power Meter and Oscilloscope.
Troubleshoot RF hardware and optimize designs based on measured results.

Mandatory Skills




Hands-on RF Amplifier Design experience is mandatory.
Experience in RF Receiver Chain design and analysis.
Solid hands-on experience with ADS and/or AWR.
Positive understanding of S-parameters, impedance matching, stability, noise figure, gain, sensitivity, P1dB, linearity and RF power.
Strong RF testing, measurement and troubleshooting skills.

Preferred Experience
Hands-on experience in T/R Module design, development, integration and testing.
Experience with GaN/GaAs RF devices.
Experience with S-band, C-band or X-band RF systems, particularly radar or aerospace applications.
Experience with RF front-end development and high-power RF systems.

Desired Profile

Robust combination of RF amplifier design, receiver-chain design, T/R module experience, RF simulation, and hands-on laboratory testing, with the ability to work from design and simulation through hardware testing and validation.

📌 Rf Design Engineer Hyderabad
🏢 Skyroot Aerospace
📍 Hyderabad