Sr. Power Electronics Design Engineer (India)

Sr. Power Electronics Design Engineer (India)

18 Nov
|
Larsen and Toubro
|
India

18 Nov

Larsen and Toubro

India

Power Electronics Design Engineer Position (Experience) Sr. Power Electronics Design Engineer – Grid-Tied Inverter 6–10+ years in power electronics hardware, experience in grid-connected product taken to certification. Department R&D; – Power Electronics Qualification B.
E./B. Tech or M. Tech in Electrical, Electronics or Power Electronics Location Coimbatore Reports to Lead / Head – Power Electronics R&D; Role Summary Power electronics engineer having hands on experience on High Power Converters, Exposure to grid-connected Power Conversion System (PCS, Bidirectional AC to DC) for BESS and solar applications. Product development experience from architecture through prototype, validation and certification support. Required Skills
• Hands-on design of 3-phase grid-connected converters (PCS, inverters, active front ends) above 50 kW.
• Strong knowledge of gate-drive design, SiC/IGBT switching behaviour, and dead-time, EMI and layout trade-offs.
• Experience with grid-interface hardware: LCL filters, contactors, breakers, pre-charge, surge and EMI filters.
• Preferred proficiency in Altium/OrCAD/Allegro and in simulation tools.
• Valuable understanding of safety, isolation, creepage and clearance, and thermal design.

Key Responsibilities
• Own design & Development from Requirement to production release for Power conversion system
• Define Power Conversion System architecture like 3-phase two-level or three-level topology, DC link, LCL filter and DC/AC interface to the battery or PV side.
• Select and design power stages using SiC/IGBT modules:



loss and thermal analysis, busbar and layout design, snubber and DC-link capacitor selection.
• Design the LCL filter, magnetics, and pre-charge and contactor circuits.
• Design the control card and interface boards: DSP/MCU control card, isolated gate-driver boards with desaturation and short-circuit protection and active Miller clamp.
• Design the sensing chain: grid and DC voltage sensing, Hall/shunt current sensing, isolated ADC paths and temperature sensing.
• Design auxiliary power supplies, fan and cooling control, and the interlock and emergency-stop (E-stop) chain.
• Build protection hardware: over-current, over-voltage, ground fault, insulation monitoring and anti-islanding hardware support.
• Perform schematic capture, multilayer PCB layout guidance
• Simulation tools à LTspice, PLECS, PSIM or MATLAB/Simulink).
• Execute DFMEA, reliability and derating analysis, and design reviews.
• Lead bring-up and validation: Grid-simulator testing, regenerative load tests, efficiency and THD measurement, thermal and EMI/EMC pre-compliance.
• Support type testing and certification against IEC 62477-1, IEC 62109, IEC 61000 series, IEC 62116 and applicable grid codes (CEA India, IEEE 1547, UL 1741, VDE-AR-N 4105/4110).
• Coordinate with mechanical, firmware and vendor teams; prepare BOMs and production documentation. Preferred
• Experience with 1000/1500 V DC systems, BESS or MW-scale PCS.
• Knowledge of 3-level (NPC/T-type) topologies and parallel module operation.

📌 Sr. Power Electronics Design Engineer (India)
🏢 Larsen and Toubro
📍 India

Reply to this offer

Impress this employer describing Your skills and abilities, fill out the form below and leave Your personal touch in the presentation letter.

Subscribe to this job alert:

Get the latest job offers by email for: sr. power electronics design engineer (india) / india

Subscribe to this job alert:

Get the latest job offers by email for: sr. power electronics design engineer (india) / india