18 Nov
|
Larsen u0026 Toubro
|
Tamil Nadu
18 Nov
Larsen u0026 Toubro
Tamil Nadu
Power Electronics Design Engineer
Position
(Experience)
Sr.
Power Electronics Design
Engineer –
- Grid-Tied Inverter
6–10+ years in power electronics hardware, experience in grid-connected product taken to certification.
Department
R&D; –
- Power Electronics
Qualification
B.E./B. Tech or M. Tech in Electrical, Electronics or Power Electronics
Location
Coimbatore
Reports to
Lead / Head –
- Power Electronics R&D;
Role Summary
Power electronics engineer having hands on experience on High Power Converters, Exposure to grid-connected Power Conversion System (PCS, Bidirectional AC to DC) for BESS and solar applications.
Product development experience from architecture through prototype, validation and certification support.
Required Skills
- Hands-on design of 3-phase grid-connected converters (PCS, inverters, active front ends) above 50 kW.
- Solid knowledge of gate-drive design, SiC/IGBT switching behaviour, and dead-time, EMI and layout trade-offs.
- Experience with grid-interface hardware: LCL filters, contactors, breakers, pre-charge, surge and EMI filters.
- Preferred proficiency in Altium/OrCAD/Allegro and in simulation tools.
- Good understanding of safety, isolation, creepage and clearance, and thermal design.
Key Responsibilities
- Own design &
- Development from Requirement to production release for Power conversion system
- Define Power Conversion System architecture like 3-phase two-level or three-level topology, DC link, LCL filter and DC/AC interface to the battery or PV side.
- Select and design power stages using SiC/IGBT modules: loss and thermal analysis, busbar and layout design, snubber and DC-link capacitor selection.
- Design the LCL filter, magnetics, and pre-charge and contactor circuits.
- Design the control card and interface boards: DSP/MCU control card, isolated gate-driver boards with desaturation and short-circuit protection and active Miller clamp.
- Design the sensing chain: grid and DC voltage sensing, Hall/shunt current sensing, isolated ADC paths and temperature sensing.
- Design auxiliary power supplies, fan and cooling control, and the interlock and emergency-stop (E-stop) chain.
- Build protection hardware: over-current, over-voltage, ground fault, insulation monitoring and anti-islanding hardware support.
- Perform schematic capture, multilayer PCB layout guidance
- Simulation tools à
- LTspice, PLECS, PSIM or MATLAB/Simulink).
- Execute DFMEA, reliability and derating analysis, and design reviews.
- Lead bring-up and validation: Grid-simulator testing, regenerative load tests, efficiency and THD measurement, thermal and EMI/EMC pre-compliance.
- Support type testing and certification against IEC 62477-1, IEC 62109, IEC 61000 series, IEC 62116 and applicable grid codes (CEA India, IEEE 1547, UL 1741, VDE-AR-N 4105/4110).
- Coordinate with mechanical, firmware and vendor teams; prepare BOMs and production documentation.
Preferred
- Experience with 1000/1500 V DC systems, BESS or MW-scale PCS.
- Knowledge of 3-level (NPC/T-type) topologies and parallel module operation.
📌 Sr. Power Electronics Design Engineer - Grid-Tied Inverter (Tamil Nadu)
🏢 Larsen u0026 Toubro
📍 Tamil Nadu