21 Nov
|
Budhia Steel
|
Jaipur
21 Nov
Budhia Steel
Jaipur
Key Roles & Responsibilities
- Incoming & Pre-Galvanizing Inspection:
- Raw fabricated steel ka surface inspection (oil, grease, rust, welding slag, burrs check karna).
- Venting & drainage holes verify karna hollow/tubular sections mein taaki air pocket na bane aur zinc entrapment/blast hazard avoid ho.
- Material straightness, distortion risk aur fabrication clearance check karna.
- Process / Pre-Treatment Monitoring:
- Chemical tank parameters monitor karna: Degreasing, Acid Pickling (HCl bath concentration & iron content), Water Rinsing, and Fluxing (specific gravity, temperature & pH).
- Drying table aur pre-heating timing track karna taaki zinc splash kam ho.
- Zinc kettle temperature monitoring ($445^circtext{C} - 455^circtext{C}$) aur zinc bath composition (pure zinc / aluminium addition) verify karna.
- Post-Galvanizing Inspection & Quality Testing:
- Coating Thickness Measurement: Elcometer / Digital DFT gauge se micron thickness check karna standard requirement ke hisaab se (e.g., 65 / 86 / 100+ microns).
- Visual Defect Inspection: Dross pimples, ash deposits, bare spots (uncoated areas), lumps, zinc runs, sags, white rust (wet storage stain) aur rough coating check karna.
- Adhesion & Uniformity Tests: Pivoted hammer test / knife test for adhesion aur Preece test (copper sulphate dip test for uniformity) perform karna standard specifications ke mutabik.
- Touch-up & Rectification:
Approved zinc-rich cold galvanizing paint ya zinc solder spray se minor defect rework standard limit mein supervise karna.
- Documentation & Audit Compliance:
- Daily Inspection Reports (DIR), Batch inspection logs, aur Test Certificates (TC / MTC) prepare karna.
- Client inspection / Third-Party Inspection (TPI) jaise RITES, PowerGrid, NTPC, BV, SGS, TUV ke physical verification aur sampling ko handle/witness karwana.
- Non-Conformance Reports (NCR) raise karna aur CAPA (Corrective & Preventive Action) maintain karna.
- Measuring instruments (DFT meter, digital thermometers, hydrometers) ka calibration record maintain rakhna.
Required Skills & Qualifications
- Education: Diploma / B.Tech in Mechanical / Metallurgy / Chemical Engineering (ya B.Sc Chemistry).
- Experience: 2 se 6 saal ka direct shop floor quality control experience Hot Dip Galvanizing plant ya structural steel galvanizing setup mein.
- Technical Knowledge:
- Relevant Galvanizing Standards: IS 2629, IS 4759, IS 6745, ASTM A123 / A153, ISO 1461.
- Hands-on experience with Elcometer (DFT meter), temperature pyrometers, hydrometers, aur chemical titration basics.
- Sound knowledge of welding defect visibility, steel chemistry impact (Sandelin effect / silicon-phosphorus reactivity).
- Skills: Blueprint/Drawing reading, TPI inspection handling, documentation skills, shop floor coordination.
Pay: ₹11,000.00 - ₹45,000.00 per month
Work Location: In person
📌 Quality Control (QC) Engineer / Inspector – Hot Dip Galvanizing (HDG)
🏢 Budhia Steel
📍 Jaipur